Home > G Screen Monitoring System >

G Screen for Jeep JK and Tacoma

G Screen Monitoring System

Alternative Views:

Our Price: $269.00

Compatibility: Jeep JK, Tacoma, & Universal dual battery kits.

Availability:: Usually Ships in 24 Hours
Product Code: 141-GS

Add Air Pressure Sensor:

Installation Instructions:

Note: This version is compatible with Jeep JK, Tacoma, and Universal dual battery kits. Our 4Runner, Tundra, or JL dual battery kits must use G Screen part number 184-GS.

NEW FEATURE! Monitor your on-board air system with our new digital air pressure sensor option! See below for details.

Monitors voltage levels
of both batteries

Remote status indicator - batteries connected or disconnected

Remote boost button - jump start the engine from inside the cab if your cranking battery is dead

  • Press the Boost Off screen for 3 seconds to manually reconnect your batteries to use the aux battery to help start the engine

Background changes color to visually show your battery status at a glance

  • Green = both batteries are fully charged, and they are connected (Screen shows Boost On - this is the normal operating mode)

  • Yellow = the cranking battery is below 12.7v, and they are disconnected (Screen shows Boost Off)

  • Red = at least 1 battery is below 12v. The screen will blink red a few times per minute to get your attention

Backgound light turns off after about 45 seconds of inactivity

  • Preserves battery power

  • No glare while driving at night

  • Voltage and status is still visible, but without the backlighting

  • If a battery drops below 12v, the screen flashes red a few times per minute

  • Press the screen to turn the backlight on at any time

  • Adjustable contrast - hold down the software version screen to access the contrast adjustment menu

Measures approximately one cubic inch. Compact size makes it easy to mount anywhere.

Includes a 10' wiring harness for simple, clean installation

Software upgradable for future features

Order a dual battery kit at the same time for no extra shipping charges

NEW! Add the digital air pressure sensor from the options above to monitor the PSI level in your on-board air system.

Screw the sensor into an available 1/4" NPT port on your air tank or manifold

Attach the waterproof cable to the sensor, and route the cable to the G Screen. Plug the other end into the interface module.

The G Screen automatically detects the sensor and adds a new screen showing the PSI level in your tank, from 0-150 PSI.

No air hoses to run, no wiring to figure out!

Featured Media:

Motorhead Garage tv installs a G Screen
G Screen Monitoring System
Air Pressure Sensor Installation
Fitment Info
  • The single cable connection plugs directly into the port on the Genesis Offroad dual battery kit lid for the Jeep Wrangler, Toyota Tacoma, or our Universal kits.

    If you have a dual battery kit on a Toyota 4Runner, Tundra, or Jeep JL, please order part number 184-GS.

    If you have a Cole Hersee smart isolator (part numbers 48530 or 48525) already installed, not as part of a Genesis dual battery kit, order the G Screen for Cole Hersee smart isolators.

Share your knowledge of this product. Be the first to write a review »